Hanwha QNE-8011R 5MP IP Compact Flateye Camera with IR — IP67 / IK10 Vandal-Rated Indoor / Semi-Outdoor

Hanwha QNE-8011R — 5MP IP Compact Flateye Camera with IR, IP67 / IK10 Rated

The Hanwha QNE-8011R is a 5MP IP super-compact flateye camera from Hanwha Vision’s Wisenet Q series — purpose-built for premium indoor and semi-outdoor positions where the camera should be discreet (low-profile flush-mount form factor) but also vandal-rated and water-resistant. Same 1/2.8” CMOS sensor and 2.8 mm F2.0 lens as the QND-8010R standard indoor dome, but with IP67 weatherproof + IK10 vandal housing and a wider operating temperature range that lets it handle environments a standard indoor camera couldn’t.

For Chicago apartment lobbies, school corridors, retail interiors, hotel hallways, healthcare facilities with disinfection protocols, food-preparation areas, indoor pools, and any indoor or semi-outdoor position where vandal resistance + water resistance + low-profile architecture matter, the QNE-8011R is one of our standard picks.

Why the Flateye Form Factor

Traditional dome cameras have a curved bubble that visibly protrudes from the ceiling — fine for industrial or back-of-house spaces, but visually intrusive in modern lobbies, boutique retail, hospitality, and office reception. The flateye design keeps the lens behind a flat glass surface flush with the housing — the camera is much less noticeable from below. At Ø 125 × 87 mm, the QNE-8011R is one of the smaller cameras in its category.

For Chicago commercial properties where the architecture matters — hotel lobbies, high-end retail, professional offices, healthcare reception — this form factor lets the camera do its job without disrupting the look of the space.

IP67 + IK10 — Where the QNE-8011R Differs From the QND-8010R

The QND-8010R and QNE-8011R share the same image-sensing internals (1/2.8” 5MP CMOS, 2.8 mm F2.0 lens, 20 m IR, 120 dB WDR, Wisenet Q analytics). The differentiator is environmental rating:

The QNE-8011R is the right pick at:

• Vandal-prone tenant-accessible positions — apartment lobbies, mailrooms, ground-floor retail, school corridors, parking-deck doors
• Semi-outdoor positions — covered entries, awning-protected exterior hallways, parking-deck soffits, breezeways, sheltered loading-dock approaches
• High-humidity indoor environments — food preparation, commercial kitchens, indoor pools, vehicle wash bays, cold-storage rooms
• Healthcare facilities with disinfection protocols — pressure-washing, chemical wipe-down, frequent cleaning
• Polar-vortex-exposed positions in semi-conditioned space — unheated apartment vestibules, exterior-adjacent corridors

The QND-8010R is the right pick at typical conditioned indoor positions (office lobbies, retail interiors with consistent climate, professional offices) where the lower per-camera cost matters.

Built-In IR — Where the QNE-8011R Differs From the ANE-L7012L

The Wisenet A flateye ANE-L7012L shares the same general flateye form factor and IP/IK ratings, but with two key differences:

The ANE-L7012L’s F1.2 fast lens is exceptional for low-ambient-light indoor scenes (premium lobbies, hospitality interiors with dim lighting after hours) where IR illumination would create reflection artifacts on glass and shiny surfaces. The QNE-8011R’s IR illumination wins at scenes that go fully dark — apartment mailrooms after lights out, parking-deck pedestrian doors at 3 AM, semi-outdoor positions with no overhead lighting.

Where the Wide 2.8 mm F2.0 Lens Wins

The 2.8 mm fixed F2.0 lens produces a 104.4° horizontal field of view — wide enough to cover an entire commercial entrance, full corridor end, mailroom, or small retail floor section from a single ceiling-mounted flateye. Combined with 5MP resolution, the camera captures usable identification detail across the full wide frame.

Wisenet Q Edge Analytics + Defog

Standard Wisenet Q analytics: defocus detection, directional detection, motion detection (with 4 polygonal zones for selective monitoring), enter/exit zones, tampering, virtual line. Plus Defog image processing for scenes with humidity or atmospheric interference (useful at indoor pool areas, semi-outdoor positions with morning fog).

The QNE-8011R is also DORI compliant per EN62676-4 — Hanwha publishes standardized detect / observe / recognize / identify range performance against the European camera-quality standard. Useful when project specifications require DORI-validated cameras.

No Audio or Alarm I/O — Use the QNV-7082R for Those Features

The QNE-8011R does not support audio capture or have discrete alarm I/O terminals. For indoor flush-mount positions with audio capture and alarm I/O requirements, the Hanwha P-series PND-A9081RF is the right pick (mic in / line in selectable, line out, 2 configurable I/O ports). For outdoor varifocal positions with audio and alarm I/O, the QNV-7082R outdoor varifocal vandal dome supports both.

Cloud-Ready Status

The QNE-8011R is a standard ONVIF Profile S / G / T camera designed for traditional NVR / VMS architecture. For cloud-direct camera architecture (camera writes straight to cloud, no on-premise NVR), use the PND-A9081RF — Hanwha’s P-series indoor flush-mount AI dome with CloudConnector capability.

Professional Installation by Vidimost in Chicago

Vidimost LLC installs Hanwha Wisenet Q-series cameras across Chicago and the surrounding suburbs. The QNE-8011R is our standard Wisenet Q flush-mount flateye pick for vandal-prone indoor positions, semi-outdoor protected scenes, high-humidity indoor environments, and architecturally clean interiors needing low-profile cameras.

Our scope on a typical project includes site walkthrough, mounting (typically ceiling, sometimes wall), cable runs (Cat6, plenum-rated where required), PoE switch and NVR sizing, NVR configuration, motion-zone tuning (4 polygonal zones), hallway-view setup where applicable, remote viewing setup, and property manager training. Contact us for a free site walkthrough and quote.